The BaitShop Homepage
Forum Home Forum Home > FireArms, et cetera > Metallic Cartridge Handloading and Bullet Casting
  New Posts New Posts RSS Feed - Lead flux for casting
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

This site is completely supported by donations; there are no corporate sponsors. We would be honoured if you would consider a small donation, to be used exclusively for forum expenses.



Thank you, from the BaitShop Boyz!

Lead flux for casting
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
d4570 View Drop Down
.416 Rigby
.416 Rigby
Avatar

Joined: 27 January 2004
Location: United States
Status: Offline
Points: 9961 		Post Options Post Options   Thanks (0) Thanks(0)   Quote d4570 Quote  Post ReplyReply Direct Link To This Post Topic: Lead flux for casting
    Posted: 23 February 2022 at 20:25
Do any of you bullet casters use a flux?
Sawdust I here works. Wax and grease works (?) but can smoke and take tin out of your mix.
Can a person use powered Graphite?
It's all carbon and that's what happens to sawdust. I'm going to try it.
Remember: Four boxes keep us free ,the soap box, the ballot box, the jury box, AND the cartridge box
Back to Top
deaddog View Drop Down
Administrator
Administrator
Avatar
*AKA The Flying Gun*

Joined: 23 April 2004
Location: Svalbard
Status: Offline
Points: 991201 		Post Options Post Options   Thanks (0) Thanks(0)   Quote deaddog Quote  Post ReplyReply Direct Link To This Post Posted: 24 February 2022 at 09:50
Candle wax. Nothing scientific about my method or timing. 
Endeavor to persevere.
Back to Top
d4570 View Drop Down
.416 Rigby
.416 Rigby
Avatar

Joined: 27 January 2004
Location: United States
Status: Offline
Points: 9961 		Post Options Post Options   Thanks (0) Thanks(0)   Quote d4570 Quote  Post ReplyReply Direct Link To This Post Posted: 24 February 2022 at 12:58

I have 5 pounds of graphite I use to tumble lead shot.
It sounded like it's the carbon that is needed as a "Flux" 
SO I put in about a table spoon May be to much, of the graphite after the lead was melted and before it got "HOT".
I ran it about 750* no smoke and NO slag on top.
It seemed to work very well, the bullets came out looking great, I did 160, they cast right at 303/304 grains. I'll size them to .452 later and press on the gas checks. It's snowing again we may get an inch this time but it's BUT cold -10 right now and some wind.Clap

-
Remember: Four boxes keep us free ,the soap box, the ballot box, the jury box, AND the cartridge box
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.055 seconds.