The BaitShop Homepage
Forum Home Forum Home > FireArms, et cetera > Optics, Gear, Calls, Clothing and Other Accessories
  New Posts New Posts RSS Feed - cabela’s scope review
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

This site is completely supported by donations; there are no corporate sponsors. We would be honoured if you would consider a small donation, to be used exclusively for forum expenses.



Thank you, from the BaitShop Boyz!

Topic Closedcabela’s scope review

 Post Reply Post Reply
Author
Message
dakotasin View Drop Down
Administrator
Administrator
Avatar
a TRUE brother-in-arms!

Joined: 10 June 2003
Location: United States
Status: Offline
Points: 4099
Direct Link To This Post Topic: cabela’s scope review
    Posted: 22 September 2003 at 09:06

in order to do my load development better, meaning to develop loads at extended range, i decided i needed a scope that could handle it... also needed a warranty, sufficient clarity, resolution, decent tracking and good repeatability. since the scope would not be hunted, i was not concerned w/ weight/size. decided on the cabela's alaskan guide 6.5-20x44 (all my rifles have medium or shorter rings, so the 44 objective is the absolute largest i could have)- partly because as a 'development' scope, it made more financial sense than a leupold, and partly because when it breaks, cabela's is close by, and i'll walk out w/ a new one that day...

so... the scope... it is quite large and heavy - but that should be expected w/ all higher magnification scopes. it comes w/ a form of turrets that make adjusting the scope w/ just fingers easy, and the turrets are marked off so that the scope can be returned to zero. i really like this feature, and for the money, was pleasantly surprised to see it. each click is .25 moa. the x-hairs (duplex), are a little heavier than i like on a varminter scope, but they aren't that bad.

tracking... the scope has been pretty close in tracking, but at ranges beyond 100 yards, each click is not truly .25 moa, so it is necessary to re-check zeroes. repeatability... as long as the turrets don't get spun, where the scope was shooting today is where it will be shooting tomorrow. unfortunately, once you start spinning the turrets, this may or may not be true. overall, i am satisfied w/ repeatability, and a little disappointed in tracking, but not appalled by it.

optical quality... i think it is pretty good. it is not on par w/ a vari-x3, but it is at least the equal of a vari-x2. the cabela's scope is a touch brighter than a vari-x2, but with 8mm or so more on the objective, you'd expect that. resolution was surprisingly good. i did not expect the scope to be able to resolve 308 holes at 300 yards, but, on most surfaces it was able to. i am satisfied w/ the optical quality.

my only bitch about this scope is the eye-relief. it sucks. i would rate cartridges like the 30-06, 308, 7 rem mag, 300 wsm, and similiar as having 'moderate' recoil... i would also think that the majority of hunters shoot cartridges producing 'moderate' recoil. there were several instances where the scope hit my safety-glasses. nothing hard enough to draw blood, but hard enough that you knew you'd just been hit, and getting over that mental block for subsequent shots took a lot of effort.

based on eye-relief, if someone wanted to buy a scope for their 243 or bigger, i would reccomend they not do it. because the eye-relief is as short as it is, it can be a little uncomfortable getting the rifle/scope/shooter into a shooting position - and it probably isn't going to happen at all (comfortably) from prone.

for your 223 or 22-250, this scope is a good value for the money, if you don't mind crawling up the stock to make the shot, but outside of that, more eye-relief would sure be nice.

Hunting is not a matter of life or death; it is much more important than that.
Back to Top
Spot shooter View Drop Down
Left BSB in Disgrace
Left BSB in Disgrace

Banned

Joined: 19 June 2003
Location: Bahrain
Status: Offline
Points: 0
Direct Link To This Post Posted: 22 September 2003 at 12:36

Dakota,

    Try this one, draw circles on a target from .25 inch increments up to 3".

Put it at 300yd's and see where you can by eye (through scope) divide the circle into 4 parts with the cross hair. 

  Use all yer scopes and give us your ability to resolve portions of the dot.

Spot

Back to Top
dakotasin View Drop Down
Administrator
Administrator
Avatar
a TRUE brother-in-arms!

Joined: 10 June 2003
Location: United States
Status: Offline
Points: 4099
Direct Link To This Post Posted: 22 September 2003 at 13:32
well... i would, but the thought of doing a 'real' resolution test w/ this scope didn't cross my mind, and i just came in from the garage. which means that i just got done loading for the 300, and when that was done, i yanked the scope and put the 3-9 compact leuppie back on... i got an antelope hunt in 2 weeks, and archery deer opens this weekend - i don't have the time right now to screw around w/ this gun/scope anymore. as soon as i get a couple of free hours, i have to check the zero for the whizzum, mark off my drops, clean it up, lightly foul it, and then (hopefully, and w/ a little luck) shoot some antelopes... when my 338 comes back from the 'smith and i begin development for that, i'll try to remember to try it out, though - unless i get cut by the scope...
Hunting is not a matter of life or death; it is much more important than that.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.